When Installing On A Wall - Sony BRAVIA KDL-40V2500 Operating Instructions Manual

When Installing
on a Wall
This TV can be installed on a wall by using a wall-mount bracket (sold
separately). Be sure to use the specified Wall-Mount Bracket (see page 3).
Before mounting the TV on a wall, you must remove the Table-Top Stand
from the TV. Follow the steps below to remove the Table-Top Stand, and
then refer to the instruction guide "Installing the Wall-Mount Bracket" to
prepare the installation and mount the TV on the wall.
Do not remove the Table-Top Stand for any reason other than to wall-
mount the TV.
Follow the simple steps below to remove the Table-Top Stand:
1
Disconnect all the cables from the TV.
2
Place the TV, with its screen facing down, on a stable, soft cloth-
covered work surface.
3
Rotate the cable holder by 90 degrees, and pull it out.
4
Remove the four screws and the Table-Top Stand from the TV.
For bracket installation, refer to the instruction guide "Installing the Wall-
Mount Bracket" provided with the TV. Sufficient expertise is required in
installing this TV, especially to determine the strength of the wall for
withstanding the TV's weight. For product protection and safety reasons,
Sony strongly recommends that you use the Wall-Mount Bracket model
designed for your TV and the wall-mounting of your TV should be
performed by Sony dealers or licensed contractors.
Cable holder
Soft cloth
Be sure to store the removed screws and Table-Top Stand in a safe
place until you are ready to reattach the Table-Top Stand. Keep the
screws away from small children.
Getting Started
Table-Top stand
17