Sony BRAVIA 4-115-568-12(1) Operating Instructions Manual page 50

Condition
Channels
The desired channel cannot be
selected
Some channels are blank
Digital channels are not
displayed
Wireless communication
Delay pictures
"Wireless communication in
progress." does not disappear,
or "Wireless communication
failed." is displayed
Noisy or interrupted picture or
sound
General
Distorted picture and/or sound • Keep the unit away from electrical noise sources such as cars,
The unit turns off
automatically (the unit enters
standby mode)
The unit turns on
automatically
Some input sources cannot be
selected
The remote does not function • Replace the batteries.
A channel cannot be added to
the Favourite list
HDMI equipment does not
appear on "HDMI Device List"
Not all channels are tuned
You cannot select "Off" in
"Control for HDMI"
The "Store Display Mode: On"
message appears on the screen
50
GB
Explanation/Solution
• Switch between digital and analogue mode and select the desired digital/
analogue channel.
• Scrambled/Subscription only channel. Subscribe to the pay TV service.
• Channel is used only for data (no picture or sound).
• Contact the broadcaster for transmission details.
• Contact a local installer to find out if digital transmissions are provided
in your area.
• Upgrade to a higher gain aerial.
• Wireless communication takes time to establish after turning the power
on. About 20 seconds are needed to display pictures. Selecting "Quick
Start" may shorten the waiting time (page 30).
• When the wireless communication is disturbed, it takes about 15 seconds
to display pictures again. "Wireless communication in progress." is
displayed until pictures come back.
• Check the installation situation of the monitor and media receiver (page 4).
• Check whether wireless equipment using the same radio frequency as
this unit is working near by, or something disturbing wireless
communication of this unit is close to the unit. In such cases, keep such
equipment away from the unit or turn off the power of that equipment.
• Check the installation situation of the monitor and media receiver (page 4).
• Pictures may be distorted if somebody walks across between the monitor
and media receiver.
• Check whether wireless equipment using the same radio frequency as
this unit is working near by, or something disturbing wireless
communication of this unit is close to the unit. In such cases, keep such
equipment away from the unit or turn off the power of that equipment.
motorcycles, hair-dryers or optical equipment.
• When installing optional equipment, leave some space between the
optional equipment and the unit.
• Check the aerial/cable connection.
• Keep the aerial/cable TV cable away from other connecting cables.
• Check if the "Sleep Timer" is activated, or confirm the "Duration"
setting of "On Timer Settings" (page 30).
• If no signal is received and no operation is performed in the TV mode
for 10 minutes, the monitor automatically switches to standby mode.
• Check if the "On Timer" is activated (page 30).
• Select "AV Preset" and cancel "Skip" of the input source (page 32).
• Up to 999 channels can be stored in the Favourite list.
• Check that your equipment is "Control for HDMI" compatible
equipment.
• Check support web site for cable provide information.
http://support.sony-europe.com/TV/DVBC/
• If any "Control for HDMI" compatible audio equipment is connected to
the unit, you cannot select "Off" in this menu. If you want to change the
audio output to the monitor speaker, select "TV Speaker" in the
"Speaker" menu (page 32).
• Select "All Reset" in the "Media Receiver Set-up" menu (page 33).