Viewing Pictures From Connected Equipment - Sony BRAVIA 2-889-390-15(1) Operating Instructions Manual

Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 4)
In analogue mode, press PROG +/-, or the number
buttons, to select the video channel.
For other connected equipment
Press / repeatedly until the correct input
symbol (see below) appears on the screen.
For KDL-15G2000
AV1/ AV1:
Audio/video or RGB input signal through the scart
socket / 1.
has been connected.
AV2:
Component input signal through the Y, P
sockets / 2, and audio input signal through the
L, R sockets / 2. As for supported signal
format, please refer to "Specifications" (page 31).
AV3/ AV3:
Video input signal through the video socket
audio input signal through the L (MONO), R audio
sockets 3. appears only if the equipment is
connected to the S video socket
video socket 3, and S video input signal is input
through the S video socket
4:
RGB input signal through the PC connectors
audio input signal through the socket
For KDL-20G2000
AV1/ AV1,
Audio/video or RGB input signal through the scart
socket / 1 or 2.
source has been connected.
AV3:
Component input signal through the Y, P
sockets / 3, and audio input signal through the
L, R sockets / 3. As for supported signal
format, please refer to "Specifications" (page 31).
18
GB
appears only if an RGB source
/C , P /C
B B R
3, and
3 instead of the
3.
4, and
4.
AV2/ AV2:
appears only if an RGB
/C , P /C
B B R
AV4/
Video input signal through the video socket
audio input signal through the L (MONO), R audio
sockets 4.
connected to the S video socket
video socket
through the S video socket
Additional operations
To
Return to the normal
TV operation
Access the Input
signal index table
R
R
AV4:
appears only if the equipment is
4 instead of the
4, and S video input signal is input
4.
Do this
Press DIGITAL or ANALOG.
Press to access the Input signal
index table. (Then, only in
analogue mode, press
select an input source, press
then press .
4, and
g
.) To
F f
/ ,