Epson TM-U200 Series Manual page 7

How to connect an Epson POS printer with Ethernet Interface
(Key: 2-7 On: refers to the switch number 7 is turned On)
Confirm the initial settings of the Printer
Run the printer self test (hold down the feed button while turning on the printer). The printer will print a list of initial settings
including interface type and buffer capacity. Verify that the interface is "serial" for this type of Ethernet adapter.
Quick Test Printout, Type II Adapter
To get a configuration / status report with information about the printer and Ethernet module, along with maintenance
counts and settings, do the following:
for PRINTERS with Cover Sensor
Power the Printer up, with Ethernet Module installed .
Pop the receipt printer cover
Press the FEED button
Close the receipt printer cover
NOTE:
printout will indicate an UNKNOWN PRINTER. If this happens, cycle power, and wait for the Green LED to
start blinking. - With the module connected to a Ethernet, this delay will be shorter than if there is no
Ethernet connected and the modules spends longer looking for one.
for PRINTERS without Cover Sensor
With a powered OFF module
Set Dip-Switch 1 (on the module) to ON
Power up the unit
Status Report will print
http://www.beaglehardware.com/howtoethernet.html[3/4/2011 12:27:20 PM]
Wait for the green LED on the module to start blinking! If you proceed with this too quickly, the
Printer
Sale!
TM-U220
$129
TM-U295
$184
TM-U375
$199
TM-
U675
$199
TM-
H6000III
$349
TM-T88II
$109
TM-T88III
$139
TM-T88IV
$199
TM-T88V
$259
New
TM-U200
$99