Epson TM-U200 Series Manual page 5

How to connect an Epson POS printer with Ethernet Interface
Setting the IP Address using TMNet WinConfig
To use the UB-E02 with TCP/IP, you first need to set its IP address. You can set the IP address by using the EPSON
TMNet WinConfig or arp/ping command.
Running the TMNet WinNet configuration utility on the Computer
Once connected you can run the TMNet configuration utility to view or change the settings on the Ethernet card.
To obtain the TMNet configuration utility from Epson:
Setting the IP Address using EPSON TMNet WinConfig
1. Set the TCP/IP of your operating system.
2. Install the EPSON TMNet WinConfig.
3. Set the IP address using EPSON TMNet WinConfig.
The utility will scan for and should list the Ethernet printer.
http://www.beaglehardware.com/howtoethernet.html[3/4/2011 12:27:20 PM]
1. You may have to re-enable your wired LAN port to download the EpsonTMNetWinConfig utility.
2. Download and Install Epson's TMNetWinConfig available from
WILL be REQUIRED
3. You
4. If you do not have a log in, you will be required to register for this service (this is free and takes
less than 10 minutes). This is a process controlled by Epson not Beagle Hardware.
TECHNICAL RESOURCES
5. Click on
Ethernet INTERFACES
6. Select
download icon for the TMNetWinConfig
7. Click the
For detailed installation instructions, click here.
8.
The 'Submit' button with write settings to the printer. The
Ethernet adapter is reset when you press the 'Reset' button.
(Type IV)
to log in to access these drivers.
CONNECT-IT INTERFACES
under the
www.epsonexpert.com
Printer
Sale!
TM-U220
$129
TM-U295
$184
TM-U375
$199
TM-
U675