Sony RDR-HXD560 Operating Instructions Manual page 96

• MPEG (DVD VIDEOs only)
Selects the type of MPEG audio signal.
PCM
MPEG
• DTS (DVD VIDEOs only)
Selects whether or not to output DTS signals.
On
Off
• 48kHz/96kHz PCM (DVD VIDEOs only)
Selects the sampling frequency of the audio
signal.
48kHz/
16bit
96kHz/
24bit
b
Note
"48kHz/96kHz PCM" setting has no effect when
audio signals are output from the LINE 2 OUT (R-
AUDIO-L) jacks or LINE 1 – TV/LINE 3 jack. If
the sampling frequency is 96kHz, signals are
simply converted to analogue signals and output.
96
Select this when the recorder
is connected to an audio
component without a built-in
MPEG decoder. If you play
MPEG audio sound tracks,
the recorder outputs stereo
signals via the DIGITAL
OUT (COAXIAL) jack.
Select this when the recorder
is connected to an audio
component with a built-in
MPEG decoder.
Select this when the recorder
is connected to an audio
component with a built-in
DTS decoder.
Select this when the recorder
is connected to an audio
component without a built-in
DTS decoder.
The audio signals of DVD
VIDEOs are converted to
48 kHz/16 bit and output.
All signals containing
96 kHz/24 bit are output
without conversion.
However, the signals are
output at 48 kHz/16 bit if
copyright-protected signals
are contained.
Audio DRC (Dynamic Range Control)
(DVDs only)
Selects the dynamic range (difference
between soft and loud sounds) setting when
playing a DVD that conforms to Audio DRC.
This affects the output from the following
jacks:
– LINE 2 OUT R-AUDIO-L jacks
– LINE 1 – TV jack
– LINE 3 jack
– DIGITAL OUT (COAXIAL) jack only
when "Dolby Digital" is set to "D-PCM"
(page 95).
Standard Normally select this position.
TV Mode Makes low sounds clear even
if you turn the volume down.
Wide Gives you the feeling of
Range being at a live performance.
Downmix (DVDs only)
Switches the method for mixing down to two
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "4. Displaying
the Playing/Remaining Time and Play
Information" on page 28. This function
affects the output of the following jacks:
– LINE 2 OUT R-AUDIO-L jacks
– LINE 1 – TV jack
– LINE 3 jack
– DIGITAL OUT (COAXIAL) jack when
"Dolby Digital" is set to "D-PCM"
(page 95).
Dolby Normally select this position.
Surround
Multi-channel audio signals
are output to two channels for
enjoying surround sounds.
Normal
Multi-channel audio signals
are downmixed to two
channels for use with your
stereo.