Audio Settings (Audio) - Sony RDR-HXD560 Operating Instructions Manual

Audio Settings (Audio)

The "Audio" setup allows you to adjust the
sound according to the playback and
connection conditions.
1
Press SYSTEM MENU while the
recorder is in stop mode.
2
Select "SETUP," and press ENTER.
3
Select "Audio," and press ENTER.
The "Audio" setup appears with the
following options. The default settings
are underlined.
Audio ATT (attenuation)
If the playback sound is distorted, set this
item to "On." The recorder reduces the audio
output level.
This function affects the output of the
following jacks:
– LINE 2 OUT R-AUDIO-L jacks
– LINE 1 – TV jack
– LINE 3 jack
On
Select this when the playback
sound from the speakers is
distorted.
Off Normally select this position.
Audio Connection
The following setup items switch the method
of outputting audio signals when you connect
a component such as an amplifier (receiver)
with a digital input jack.
For connection details, see "Step 3:
Connecting the Audio Cords" on page 15.
Select "Dolby Digital," "MPEG," "DTS,"
and "48kHz/96kHz PCM" after setting
"Digital Out" to "On."
If you connect a component that does not
accept the selected audio signal, a loud noise
(or no sound) will come out from the
speakers, and may affect your ears or cause
speaker damage.
1
Select "Audio Connection" in "Audio,"
and press ENTER.
2
Select "Digital Out," and press ENTER.
On
Normally select this
position.
Off
The influence of the
digital circuit upon the
analogue circuit is
minimal.
3
Select "On," and press ENTER.
4
Set the digital output signal.
• Dolby Digital (HDD/DVDs only)
Selects the type of Dolby Digital signal.
D-PCM
Select this when the recorder
is connected to an audio
component lacking a built-in
Dolby Digital decoder. The
surround effects of output
signals are determined by the
"Downmix" setting item in
the "Audio" setup.
Dolby
Select this when the recorder
Digital is connected to an audio
component with a built-in
Dolby Digital decoder.
95
,continued