About I.link - Sony RDR-HX525 Operating Instructions Manual

LINE 3/DECODER
CVBS IN/OUT
S-Video/RGB IN
(RGB signals cannot be recorded)
S-Video OUT (downstream)
Decoder
DV IN
: 4-pin/i.LINK S100
DIGITAL OUT
0.5 Vp-p/75 ohms
COMPONENT VIDEO OUT
(Y, P /C
B B
Phono jack/Y: 1.0 Vp-p, P
P /C : 0.7 Vp-p
R R
G-LINK: mini jack
General
Power requirements: 220-240 V AC, 50/
60 Hz
Power consumption:
RDR-HX525: 42 W
RDR-HX725: 44 W
Dimensions (approx.):
430 × 65 × 328 mm (width/height/
depth) incl. projecting parts
Hard disk drive capacity:
RDR-HX525: 80 GB
RDR-HX725: 160 GB
Mass (approx.): 4.2 kg
Operating temperature: 5ºC to 35ºC
Operating humidity: 25% to 80%
Supplied accessories:
Mains lead (1)
Aerial cable (1)
Remote commander (remote) (1)
Set top box controller (1)
R6 (size AA) batteries (2)
Specifications and design are subject to
change without notice.
Compatible colour systems
This recorder is designed to record using the
PAL colour system and play back using the
PAL or NTSC colour systems.
116
: 21-pin
COAXIAL
( ): Phono jack/
, P /C ):
R R
/C : 0.7 Vp-p,
B B

About i.LINK

DV IN
The jack on this recorder is i.LINK-
compliant for digital video cameras. This
section describes the i.LINK standard and its
features.
What is i.LINK?
i.LINK is a digital serial interface for
handling digital video, digital audio and other
data in two directions between equipment
having the i.LINK jack, and for controlling
other equipment.
i.LINK-compatible equipment can be
connected by a single i.LINK cable. Possible
applications are operations and data
transactions with various digital AV
equipment. When two or more i.LINK-
compatible equipment are connected to this
recorder in a daisy chain, operations and data
transactions are possible with not only the
equipment that this recorder is connected to
but also with other devices via the directly
connected equipment.
Note, however, that the method of operation
sometimes varies according to the
characteristics and specifications of the
equipment to be connected, and that
operations and data transactions are
sometimes not possible on some connected
equipment.
Note
Normally, only one piece of equipment can be
connected to this recorder by the i.LINK cable (DV
connecting cable). When connecting this recorder
to i.LINK-compatible equipment having two or
more i.LINK jacks (DV jacks), see the instruction
manual of the equipment to be connected.
About the name "i.LINK"
i.LINK is a more familiar term for IEEE 1394
data transport bus proposed by SONY, and is
a trademark approved by many corporations.
IEEE 1394 is an international standard
standardized by the Institute of Electrical and
Electronics Engineers.