Sony RDR-GX120 Operating Instructions Manual page 43

When all of the timer settings do not fit
on the list, the scroll bar appears.
To view the hidden timer settings, press
M/m.
2
Select the timer setting you want to
check/change/cancel, and press
ENTER.
The sub-menu appears.
3
Select one of the options, and press
ENTER.
"Modify":
Changes the timer setting.
Select an item using </, and adjust
using M/m. Select "OK," and press
ENTER.
"Erase":
Erases the timer setting. Select "OK,"
and press ENTER.
"Check Overlap":
Checks for overlapped settings.
The timer setting without the
has priority over the other settings.
Select "Close" to return to the Timer List.
To change or cancel the setting, repeat
steps 2 and 3 above.
When the timer settings overlap
The programme that starts first has priority
and the second programme starts recording
only after the first programme has finished.
will be cut off
When the recordings start at the same time
The programme that is set last has priority. In
this example, timer setting B is set after A, so
the first part of timer setting A will not be
recorded.
When the end time of one recording and
the start time of another are the same
After finishing the previous recording, the
other recording may be delayed.
To scroll the list display by page (Page
mode)
Press
/
on. Each time you press
Timer List changes to the next/previous page
of timer settings.
To turn off the Timer List
Press TIMER LIST or O RETURN.
z Hint
While recording, you cannot modify the timer
mark
setting for the current recording, but you can extend
the duration of the recording time (page 39).
b
Notes
• When "PDC/VPS" is set to "On" for one or more
timer recordings, the start times may change in
the event of a broadcast delay or early start.
• Even if the timer is set, timer recordings cannot be
made while recording a programme that has
priority.
• Even if the timer is set for the same daily or
weekly programme, the timer recording cannot be
made if it overlaps with a programme that has
priority. "
setting in the Timer List. Check the priority order
of the settings.
while the list display is turned
, the entire
/
" will appear next to the overlapped
43