Table of Contents
Advertisement
82
Fig. 43: Assembling and connecting the sewing lamp transformer (2)
⑤
⑥
⑦
(5) - Terminal
(6) - Terminal
(7) - Terminal opening
6.
Loosen the 4 screws from the control front panel.
7.
Remove the control front panel.
8.
Feed the electrical connection cable (4) from the rear through
the cable duct (10) into the control.
9.
Remove the black rubber grommet (9).
10. Pierce the round slot of the rubber grommet (9) with a screw-
driver.
11. Insert the rubber grommet (9) again.
12. Press a narrow screwdriver into terminal openings (7) or (8)
to open terminals (6) and (5).
13. Connect the blue cable to the terminal (5).
14. Connect the brown cable to the terminal (6).
15. Assemble the front panel again.
⑧
(8) - Terminal opening
(9) - Rubber grommet
(10) - Cable duct
Operating Instructions 827/827-M - 01.0 - 02/2019
Setup
⑩
⑨
Advertisement
Table of Contents
