Checking The Play Information - Sony DVP-S560D Operating Instructions (DVP-S560D/S565D CD/DVD Player) Operating Instructions Manual

Digital Cinema Sound Settings
VIRTUAL MULTI DIMENSION
Uses 3D sound imaging to create an array of virtual rear
speaker positions higher than the listener from a single
pair of actual rear speakers. This mode creates 5 sets of
virtual speakers surrounding the listener at
approximately a 30˚ angle of elevation. The effect differs
according to the setting of the rear speaker position (page
56).
SIDE REAR
L R
LS RS
L: Front speaker (left)
R: Front speaker (right)
LS: Rear speaker (left)
RS: Rear speaker (right)
: Virtual speaker
z
You can select "VIRTUAL 3D SURROUND" directly
Press VIRTUAL 3D SURROUND on the player. Each time you
press the button, the mode changes.
Notes
• When you select an item, the sound cuts off for a moment.
• When the playing signal does not contain a signal for the rear
speakers, the 3D surround effects may be difficult to hear.
• Set the front speakers to form an equilateral triangle with the
listening position at the top. Otherwise the effects may be
difficult to hear even if you select "VES A," "VES B" or
"VIRTUAL SEMI MULTI DIMENSION."
• When you connect a center speaker and a subwoofer, you can
also hear the sound from the center speaker and the subwoofer.
However, when you select "VES TV," "VES A," "VES B" or
"VIRTUAL SEMI MULTI DIMENSION," the player does not
output the sound from the center speaker.
• When you select one of the VIRTUAL 3D SURROUND modes,
set the surround setting of the connected units, such as the
amplifier, to OFF.
• The sampling frequency is converted to 48 kHz when a
VIRTUAL 3D SURROUND mode is selected.
• If the player is set up to output the signal from the DIGITAL
OUT (OPTICAL or COAXIAL) connectors, the surround effect
will not be heard when you play a CD.
• When you connect 4 speakers, the surround effect will not be
heard if you use the DIGITAL OUT (OPTICAL or COAXIAL)
connectors.
36
L R
LS RS
Checking the Play
Information
You can check information such as the bit rate or the disc
layer that is being played.
While playing a disc, the approximate bit rate of the
playback picture is always displayed as Mbps (Mega bit
per second) and the audio as kbps (kilo bit per second).
Select "ADVANCED" after pressing DISPLAY.
1 2 ( 2 7 )
1 8 ( 3 4 )
C 0 1 : 3 2 : 5 5
BIT RATE
ADVANCED
Select:
x ADVANCED
The default setting is underlined.
When playing a DVD
• BIT RATE: displays the bit rate.
• LAYER: displays the layer and the pick-up point.
• OFF: turns off ADVANCED display.
PLAY
DVD
BIT RATE
384 kbps
Mbps
0 5 10
ENTER