Winegard Pathway X1 Instruction Manual page 4

4. Receiver Setup for a New
Wally Receiver
®
If using a new Wally receiver with the Pathway
receiver will go through an Installation Wizard to help with the
setup process.
Follow the on-screen instructions to program the remote control.
Step 1 of the Installation Wizard will pair the remote to the
receiver.
During Step 2, the unit will need to acquire satellites and
may update the receiver (figures 1-6).This step will require
a search initiated by the Mobile Setup screen. Fill in the
required information, and then select "Scan" to begin the
search routine (figures 1-3).
Figure 1
Figure 2
Figure 3
During the search routine, the antenna will scan for satellites.
3
X1 antenna, the
®
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
The antenna may make a slight grinding sound when searching
for satellites; this is normal and does not harm the unit.
Figure 4
Once the search routine is complete, the receiver may
update (figure 4).
Figure 5
If not already activated, the receiver will need to be activated
(figure 5). To activate the receiver, call Winegard Company at
1-866-593-0348.
The receiver may reboot automatically as part of the update
process (figure 6). If so, select the state of your current
location on the Mobile Antenna Setup screen as in figures 1
and 2. Press "Scan" to begin the search routine.
The satellite will search for and acquire satellites.
Figure 6
NOTE
If the receiver reboots at this time, restart (see figures 1 & 2).