Table of Contents
Advertisement
• When playing DVD-RW/DVD-R in VR mode: If
you connect to an AV amplifier (receiver) using
the DIGITAL OUT (COAXIAL or OPTICAL)/
HDMI OUT jack and want to switch between the
sound tracks, set "DOLBY DIGITAL" to "D-
PCM" in "AUDIO SETUP."
Checking the audio signal
format
You can check the audio signal format by
pressing
(audio) repeatedly during
playback. The format of the current audio
signal (Dolby Digital, DTS, PCM, etc.)
appears as shown below.
When playing a DVD VIDEO
Example:
Dolby Digital 5.1 ch
Rear (L/R)
1 : ENGLISH DOLBY DIGITAL
Front (L/R)
+ Center
Example:
Dolby Digital 3 ch
Front (L/R)
2 : SPANISH DOLBY DIGITAL
When playing a DivX video file on a DATA
CD or a DATA DVD
Example:
MP3 audio
1:
MP3 128k
Bit rate
LFE (Low
Frequency Effect)
3 / 2 .1
Rear (Monaural)
2 / 1
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
• Front (L)
• Front (R)
• Centre
• Rear (L)
• Rear (R)
• Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound's
monaural rear audio signals.
• LFE (Low Frequency Effect) signal
Note
If "DTS" in "AUDIO SETUP" is set to "OFF," the
DTS track selection option will not appear on the
screen even if the disc contains DTS tracks
(page 71).
41
Hide quick links:
Advertisement
Table of Contents
