Welding Guns, Torches And Accessories - Lincoln Electric LF-72 Operator's Manual

A-9
WELDING GUNS, TORCHES AND
ACCESSORIES
GUN RECEIVER BUSHING
The LF-72 wire feeder comes with a K1500-2 gun
receiver bushing.
MAGNUM GUN AND CABLE ASSEMBLIES
The LF-72 wire feeder model will accept a number of
optional gun and cable assemblies.
1. Turn off power at the welding power source.
2. Unscrew Thumb screw on Wire Drive Unit, until tip
of screw no longer protrudes into gun bushing
hole as seen from the front of machine.
3. Fully insert the gun cable connector end into the
gun receiver bushing and gently tighten the thumb
screw as show in Figure A.5.
4. Connect the gun trigger connector to the trigger
receptacle. Make sure that the key ways are
aligned and insert.
INSTALLATION
LF-72
A-9