Kenwood KDC-X5200BTM Instruction Manual page 15

BLUETOOTH®
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
MIC GAIN LEVEL –10 to LEVEL +10 (LEVEL –4): The sensitivity of the
microphone increases as the number increased.
NR LEVEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the noise reduction
level until the least noise is being heard during a phone
conversation.
ECHO CANCEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the echo cancellation
delay time until the least echo is being heard during a phone
conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER
BATTERY/SIGNAL*
.
* Functionality depends on the type of the phone used.
Default: XX
Make a call
You can make a call from the call history, phonebook, or dialing the number. Call
by voice is also possible if your mobile phone has the feature.
1 Press
"(First device name)" appears.
• If two Bluetooth phones are connected, press
another phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step
instructions stated on the selected item.
4
Press and hold
To return to the previous setting item, press
CALL HISTORY
.
1 to 30: The unit answers incoming call automatically in the selected time (in
seconds). ; OFF: Cancels.
AUTO: Shows the strength of the battery and signal when the unit detects a
Bluetooth device and the Bluetooth device is connected. ; OFF: Cancels.
to enter Bluetooth mode.
2
until the desired item is selected/activated or follow the
to exit.
(Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "INCOMING", "OUTGOING", or "MISSED" is shown on the lower part of the
display to indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
Default: XX
again to switch to
.
15
ENGLISH