Advertisement
Switching the product on and off
Press the on/off button once to switch the
product on or off (Fig. 7).
Beard trimming
- If you are trimming for the first time, be
careful. Do not move the product too
fast. Make smooth and gentle
movements.
- When you trim for the first time, start at
the highest length setting to familiarize
yourself with the product.
- Trimming facial hair is easier when skin
and hair are dry.
- Always comb the beard and/or
moustache with a fine comb before you
start trimming
Trimming with guard
1 Make sure the product is switched off.
2 Slide the guard into the guiding grooves
on both sides of the product ('click') (Fig.
8).
3 Turn the zoom wheel to select the
desired length setting (Fig. 9). The
selected length setting is shown on the
front of the product.
-
You can select a length from 1/64 in to
9/32 in (0.4 mm to 7 mm).
4 Switch on the product.
5 To trim most effectively, move the
product against the hair growth direction.
Make sure that the surface of the guard
always stays in contact with the skin (Fig.
10).
Note: Since hairs do not all grow in the
same direction, you may want to try
different trimming positions (i.e. upwards,
downwards, or across). Practice is best
for optimum results.
- If cut hairs have accumulated in the
guard during use, switch off the product,
remove the guard and blow and/or
shake the hair out of the guard.
6 Switch off and clean the product after
each use (see 'Cleaning').
Trimming without guard
If you trim without guard, your hair is cut off
close to the skin. You can use the trimming
head without guard to:
- Define your hair line
- Trim the nape of the neck
- Remove single unwanted hairs
1 Make sure the product is switched off.
2 Remove the guard by pulling it off the
product (Fig. 11).
-
Never pull at the flexible top of the
guard. always pull at the sides.
3 Switch on the product.
4 Make well-controlled movements. Touch
the hair lightly with the trimmer.
-
For a comfortable trim close to your
skin, place the flat side of the trimming
head against your skin and make
strokes in the desired direction (Fig.
12).
-
For contouring hold the trimming
head perpendicular to the skin and
move the trimming head upwards or
downwards with gentle pressure (Fig.
13).
5 Switch off and clean the product after
each use (see 'Cleaning').
Body trimming with the body guard
You can use the body guard to trim hairs
below the neckline.
- Make sure that the product is fully
charged before you start trimming.
- Make sure hair is clean and dry, as wet
hair tends to stick to the body.
- Take your time and do not move the
product too fast. Make smooth and
gentle movements.
- Be careful when you trim sensitive areas.
- Always use the body guard when you
trim sensitive areas.
1 Slide the body guards into the guiding
grooves on both sides of the product
('click') (Fig. 14).
2 Turn the zoom wheel to select the
desired length setting (Fig. 15).
The body comb cuts hair to a length of
3/64-23/32 in (1-18 mm).
Note: Make sure you set the length
setting to 1/8 in. (3 mm) or longer when
you trim sensitive areas.
3 The setting selected is shown on the
front of the product and is equal to the
hair length that remains after trimming.
Advertisement
