Disconnecting The Camera; Capturing Images With The Camera - Sony VAIO PCGA-UVC10 Operating Instructions Manual

Visual communication camera
Table of Contents

Advertisement

Disconnecting the camera

Notes
• When disconnecting the camera while the power to your computer is turned on, be sure
to observe the following procedure. Doing the steps out of sequence may cause your
computer to malfunction.
• When the power to your computer is turned off, you do not need to perform Step 1
below. However, if you disconnect the USB cable while your computer is in energy
saving mode and then connect it again, the camera may not be recognized.
1
Close the software used by the camera.
2
Disconnect the USB cable, and then disconnect the camera.
Notes
• If you pull on the cable itself when disconnecting the USB cable, you may damage
• When removing the camera from the mounting adapter, spread the arm plate with

Capturing images with the camera

You can use Network Smart Capture preinstalled on your computer to
capture images with the camera.
1
Connect the camera to your computer.
The camera's USB cable can be disconnected or connected while the
power to your computer is turned on.
For details, see "Connecting the camera to a notebook" (page 12) or
"Connecting the camera to a desktop computer" (page 13).
2
Start up Network Smart Capture.
the cable. Make sure you hold onto the connector when disconnecting the cable.
your hand, and then remove the camera.
Continued on next page
GB
15

Advertisement

Table of Contents
loading

Table of Contents