Carrier And Rocker Removal - IBM Selectric Maintenance Manual

FIGURE 51. Carrier Shoe Removal
3. Work the carrier out from under the escapement bracket
to the ri ght.
4. Remove the nut from the carrier-shoe stud and remove
the shoe (#1, Figure 51).
5. The following adjustments should be checked after the
carrier-shoe is replaced.
a. Carrier 'shoe
b. Escapement bracket
c. Tab
CARRIER AND ROCKER REMOVAL
1. Remove mounting screws (#1, Figure 52).
2. Remove card holders (#1, Figure 53) . .
3. Disconnect ribbon lift spring (#3, Figure 53).
4. Release rotate spring tension (#4, Figure 53).
5. Remove tilt pulley spring (#5, Figure·53).
6. Remove tape anchor screw (#6, Figure 53).
7. Remove tapes (#7, Fi gure 53).
8.
Remove tape wiper (#8, Figure 53) if present.
9. Remove escapement bracket mounting screws (# 1 0, Fi g-
ure 53).
10. Re.move transport spring bracket screw (#1, Figure 54)
(Early printers only)
11 . Remove print shaft gear (not shown).
12. Remove print shaft (#11, Figure 53).
13. Remove carrier and rocker assembly.
FIGURE 52. Carrier and Rocker Removal
FIGURE 53. Carrier and Rocker Removal
FIGURE 54. Carrier and Rocker Removal
NOTE: If rocker removal is necessary,'complete the
f~lIow­
ing steps:
14. Remove anvil striker (#1, Figure 55).
15. Remove rotate spring, cage and pulley (#2, Figure 55).
3-14
16. Remove tape guide (#3, Figure 55).
17. Remove "C" clip on rocker shaft (#4, Figure 55).
18. Loosen rocker shaft set screw and remove rocker shaft
(#5, Figure 55).
19. Check carrier and rocker and alignment adjustments after
reassembly.