Operational Cam Follower; Operational Contact Removal; Operational Magnet Assembly Removal - IBM Selectric Maintenance Manual

FIGURE 40. Operational Cam Check Pawl and Escapement
Cam Follower Removal
OPERATIONAL CAM FOLLOWER REMOVAL
1. Remove the C-c1ips from the cam-follower pivot shaft
(#1, Figure 41).
2. Remove the auxiliary cam-follower spring (#2, Figure4l).
3. Work the shaft to the right until the desired part is free.
FIGURE 41. Operational Cam Follower Removal
OPERATIONAL CONTACT REMOVAL
1. Remove the right rear mounting leg (#1, Figure 42).
2. Remove the two mounting screws (#2, Figure 42) and re
move the contact assembly.
3-11
FIGURE 42. Operational Contact Removal
OPERATIONAL MAGNET ASSEMBLY REMOVAL
1. Perform the Shift-Magnet-Assembly Removal.
2. Remove the actuator-arm spring (#1, Figure 43).
3. Remove the two mounting screws (#2, Figure 43).
4. Remove the actuator-arm pivot screw (#3, Figure 43).
5. Remove the armature-link clevises (#4, Figure 43).
6. Remove the mounting screw (#1, Figure 44).
7. Remove the nut (#2, Figure 44) and carefully remove the
magnet assembly.
FIGURE 43. Operational Magnet Assembly Removal