Nightframing - Sony DSC-V1 Operating Instructions (English) Operating Instructions Manual

• While using the NightShot function, you cannot
use the following functions:
– Focus Preset
– LCD screen off
– AE LOCK
– Shooting with hologram AF
– Shooting with the flash
• While using the NightShot function:
– The white balance is set to Auto.
– The metering mode is set to center weighted.
– If you perform any invalid operation, the
indicator flashes, and the "Night shot"
indicator lights for about five seconds.
However, if you press v ( ) in Exposure
Bracket, Multi Burst or Burst 3 mode, the
BRK/ / indicator flashes.
• Do not use the NightShot function in bright
places (e.g. outdoors in the daytime). This may
cause your camera to malfunction.
• Images shot using the NightShot function are
recorded with a green tint as if viewing an LCD
screen.

NightFraming

The NightFraming function enables you to
check a subject even at night and then
record with natural colors using the flash.
a Set the mode dial to
(Clip Motion).
b Set NIGHTSHOT/
NIGHTFRAMING lever to
NIGHTFRAMING.
The and "Night framing"
indicators light. The "Night framing"
indicator turns off after about 5
seconds.
60
min
101
VGA
98
S AF
"Night framing"
c Press and hold the shutter
button halfway down.
When [Hologram AF] is set to [Off],
you may not get a clear focus. Setting
[Hologram AF] to [Auto] is
recommended.
d Press the shutter button fully
down.
The shutter sounds, the flash strobes
and the image is recorded.
, P or
To cancel the NightFraming
function
Set NIGHTSHOT/NIGHTFRAMING
lever to z.
• While using the NightFraming function, you
cannot use the following functions:
– LCD screen off
– AE LOCK
– Focus Preset
• While using the NightFraming function:
– The white balance is set to Auto.
– The metering mode is set to multi-pattern
metering.
– The AF range finder is fixed to the center.
– If you perform any invalid operation while
using the NightFraming function, the
indicator flashes and the "Night framing"
indicator lights for about five seconds.
• When you press the shutter button halfway
down you will hear a sound, but this is not the
sound of the shutter releasing. The image is not
recorded yet.
• The flash does not function when recording in
Burst 3 and in Exposure Bracket modes. If you
press v ( ) the BRK/
indicator flashes.
57