Sony DSC-V1 Operating Instructions (English) Operating Instructions Manual page 12

Number of images and battery
life that can be recorded/
viewed
The tables show the approximate number of
images and the battery life that can be recorded/
viewed when you shoot images in normal mode
with a fully charged battery pack at a temperature
of 25°C (77°F). The numbers of images that can
be recorded or viewed take into account changing
the supplied "Memory Stick" as necessary. Note
that the actual numbers may be less than
indicated depending on the conditions of use.
Shooting still images
Under the average conditions
NP-FC11 (supplied)
Image
LCD No. of
size
screen images
On Approx. 150 Approx. 75
5.0M
Off Approx. 200 Approx. 100
On Approx. 150 Approx. 75
VGA
Off Approx. 200 Approx. 100
1)
Shooting in the following situations:
– [P. Quality] is set to [Fine]
– Shooting one time every 30 seconds
– The zoom is switched alternately between
the W and T ends
– The flash strobes once every two times
– The power turns on and off once every ten
times
– [AF Mode] is set to [Single] in the SET UP
settings
12
Viewing still images
Image size
5.0M
VGA
2)
Viewing single images in order at about three
second intervals
Shooting movies
NP-FC11 (supplied)
LCD screen on
Approx. 85
1)
3)
Shooting continuously at 160 (Mail)
size
Battery life
• The number of images and the battery life that
(min.)
can be recorded/viewed are decreased under the
following conditions:
– The surrounding temperature is low
– The flash is used
– The camera has been turned on and off many
times
– The zoom is used frequently
– [LCD Backlight] is set to [Bright] in the SET
UP settings
– [Power Save] is set to [Off] in the SET UP
settings
– The battery power is low.
The battery capacity decreases as you use it
more and more and as time passes (page 121).
– [AF Mode] is set to [Monitor] or [Cont] in the
SET UP settings
2)
NP-FC11 (supplied)
No. of Battery life
images (min.)
Approx. 3500 Approx. 175
Approx. 3500 Approx. 175
3)
LCD screen off
Approx. 130
image
The Power Save function
When the Power Save function is activated,
you can shoot for a longer period of time.
Set the mode dial to SET UP, and set
[Power Save] in (Setup 1) to [On]. The
1
factory setting is [Off] (page 117).
• [Power Save] appears only when you use the
camera with the battery back.
When [Power Save] is set to [On]
While charging the flash, the /CHG lamp
flashes and the LCD screen turns off. After the
charging is complete, the lamp goes out and
the LCD screen turns on.