Advertisement
R
epair
CAUTION: Unplug the machine and remove the saw blade from the machine for safety before
repair/ maintenance !
[1] NECESSARY REPAIRING TOOLS
Code No.
Descriptions
1R003
Retaining ring S pliers ST-2N
1R207
45 degrees set square
1R208
90 degrees set square
1R269
Bearing extractor
1R291
Retaining ring S and R pliers
Bearing retainer wrench
1R316
[2] LUBRICATION
When assembling Gear section;
1) Wash the inside of Gear housing complete clean with kerosene.
2) Put 30cc Lubricant oil VG220 (Makita part No. 041005-1A: 20 liters per tank) as illustrated in Fig. 1 to protect parts
and product from unusual abrasion.
Fig. 1
Gear housing complete
[3] DISASSEMBLY/ ASSEMBLY OF BASE
DISASSEMBLING
Remove Bow stop rings E-12 on Depth guide. (Fig. 2) Lever plate, M8-13 Hex nut, Flat washer 8 (small) and Flat washer 8
(large) can be removed as illustrated in Fig. 3.
Fig. 2
Lever plate
Bow stop ring E-12
M8-13 Hex nut
Twist the Bow stop ring E-12 using slotted screw-
driver to remove it from a groove of M8-13 Hex nut.
Removing Retaining ring S-42 to separate Safety cover from Gear housing complete
Adjusting
Saw blade to be at right angle with Base
Removing Ball bearings
Disassembling / Assembling Retaining rings
Disassembling / Assembling Bearing retainers
Put Lubricant oil VG220 or the following API (American Petroleum Institute) GL-4
vehicle gear oil into Gear room from the Armature gear shaft installation side.
Nippon Oil
Idemitsu
Hypoid Gear
Apollo Gear
80, 90, 140
HE-80W, 90
Castrol
BP
TAF-X 75W-90
MTF-S 75W-90
Gear Oil 80W-90
MTF 80W-90
Fig. 3
M8-13 Hex nut
Lever plate
Bow stop
Bow stop ring E-12
ring E-12
Use for
COSMO
Shell
Gear GL-4
Shell Spirax EP75W-
80, 90, 140
85, 80, 90, 140
ELF
TOTAL
TOTAL EP
Gearelf HTX 740
80W85, 80W90
Retro G 80W
TOTAL Transmission
X1 75W90, T1 75W80
Flat washer 8 (small)
Flat washer 8 (large)
Depth guide
P 2/ 8
Advertisement
