Viewing Images On A Tv Screen - Sony CSS-HD2 Operating Instructions Manual


Notes
After attaching the camera to the Cyber-shot

Station, the CHARGE lamp may blink slowly for
3 to 10 seconds. This indicates communication
between the camera and the Cyber-shot Station,
and it is not a malfunction.
If CHARGE lamp does not light or blinks for

more than 10 seconds, refer to "Troubleshooting".
Charging temperature
The temperature range for charging is 0 °C to
40 °C (32 °F to 104 °F). However, to provide
maximum battery efficiency, the recommended
temperature range when charging is 10 °C to
30 °C (50 °F to 86 °F).
On battery life
The battery life is limited. Battery capacity

decreases little by little as you use it more and
more, and as time passes. If the battery operating
time seems shortened considerably, a probable
cause is that the battery pack has reached the end
of its life. Buy a new battery pack.
The battery life varies according to how it

is stored and the operating conditions and
environment in which each battery pack is used.
Viewing images on a TV
screen
You can playback images by connecting the Cyber-
shot Station to the TV with the A/V connecting
cable (supplied) or the Component A/V Cable
(supplied).
Refer to the operating instructions supplied with
the TV for connection.
1
Viewing images on a high-definition TV
Connect the A/V OUT jack of the Cyber-shot
Station and the Component AV jacks of the TV.
Component A/V Cable
Red
Audio
White
Y
Green
P /C
Blue
b b
P /C
Red
r r
Viewing images on TVs other than high-
definition TV
Connect the A/V OUT jack of the Cyber-shot
Station and the audio/video input jacks of the
TV.
A/V connecting cable
Turn off the TV before connecting the Cyber-

shot Station and TV with the Component
A/V Cable.
The signal format to be output from the A/V

OUT jack depends on the camera setting.
To view the 1080i format images, you need a

TV compatible with 1080i format.
The audio to be output from the Cyber-shot

Station via the A/V OUT jack is monaural.
The Cyber-shot Station is not compatible with

the S-VIDEO connecting cable.

Turn on the power by pressing the
(playback) button of the camera or the
POWER button on the Remote Commander.

Tips
The buttons on the camera or the Remote

Commander may not function immediately
after the camera is attached to the Cyber-
shot Station. This occurs when the camera is
booting up and is not a malfunction. Wait for
about 10 seconds.

Turn on the TV and set the input switch to
the input connected in step 1.

Press / on the Control buttons of the
Remote Commander to select the image.
You can also select the image by pressing /
on the Control buttons of the camera.
The Cyber-shot Station is compatible with both

NTSC and PAL TV systems. For further details,
see the operating instructions supplied with the
camera.
Red
Audio
White
Video
Yellow
1-GB