Set Up - Sony CSS-TNA Operating Instructions Manual

Set up

Preparing the Cyber-shot Station
Remove the caution sheet before using the
Cyber-shot Station for the first time.
1
Select the Adaptor plate.
Use the Adaptor plate designated for your
camera. See the mark on the Adaptor plate
and select one as followed by the list
below.
Adaptor plate for
DSC-T5
Adaptor plate for
DSC-N1
Adaptor plate for
DSC-T9
2
Attach the Adaptor plate.
Attach the Adaptor plate to the Cyber-shot
Station upright until it clicks.
– Be sure to attach the designated Adaptor
plate before using the Cyber-shot
Station.
– Using the Cyber-shot Station without
attaching the Adaptor plate may cause a
malfunction.
3
Connect the AC Adaptor to the DC IN
jack of the Cyber-shot Station.
AC Power cord
(mains lead)
To remove the Adaptor plate
Slide the EJECT switch on the Cyber-shot
Station (1) and lift the Adaptor plate upright
(2).
To use your Cyber-shot Station abroad
- Power sources
You can use the Cyber-shot Station and the AC
Adaptor (supplied) in any country or region
where the power supply is within 100 V to
240 V AC 50/60 Hz.
Use a commercially available AC plug
adaptor, if necessary, depending on the design
of the wall outlet (wall socket).
AC plug adaptor
(not supplied)
Do not use an electronic transformer
(travel converter), as this may cause a
malfunction.
Cyber-shot
Station
DC plug
AC Adaptor
To a wall
outlet
(wall socket)
9-GB