Operating A Cable Box Or Satellite Receiver (Sat); Setting The Manufacturer's Code; Operating A Cable Box Or Satellite Receiver - Sony KP-57XBR10W Operating Instructions Manual

Operating a Cable Box
or Satellite Receiver
(SAT)
Setting the Manufacturer's
Code
You can program the supplied remote control to
operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE (FUNCTION),
and the 0-9 buttons to enter the manufacturer's
code number (see the following chart), then press
ENTER.
For example, to operate a Sony satellite receiver:
FUNCTION
CODE SET SAT/CABLE
8
56
Manufacturer code numbers (cable Manufacturer code numbers (cable
Manufacturer code numbers (cable Manufacturer code numbers (cable
box) box)
box) box)
Manufacturer
Gemini
Hamlin/Regal
Jerrold/G. I.
Macom
Magnavox
Oak
Panasonic
Philips
Pioneer
Samsung
Scientific Atlanta
Tocom
Zenith
Manufacturer code numbers Manufacturer code numbers Manufacturer code numbers Manufacturer code numbers
(Satellite receiver) (Satellite receiver) (Satellite receiver) (Satellite receiver)
ENTER
0 1
Manufacturer
Sony
General Electric
RCA/PROSCAN
Operating a cable box or
satellite receiver
1
Press SAT/CABLE (POWER) [Green Button]
to turn on/off the cable box or satellite receiver.
2
Press SAT/CABLE (FUNCTION).
3
For other operations, refer to the operating
instructions that come with the equipment.
Blue-labeled buttons such as the GUIDE
button can be used only with a satellite
Code
233
222, 223, 224, 225, 226
201, 202, 203, 204, 205, 222,
206, 207, 208, 218
230, 231, 232
234
227, 228, 229
219, 220, 221
236, 237, 238, 239, 240, 241
214, 215
235
209, 210, 211
216, 217
212, 213
Code number
801 (preset code for remote
control)
802
802
receiver.
If the remote control doesn't work If the remote control doesn't work If the remote control doesn't work If the remote control doesn't work
• Try repeating the set up procedures using the
other codes listed for your equipment.
To operate the projection TV To operate the projection TV To operate the projection TV To operate the projection TV
Press TV (FUNCTION). Then use the projection
TV control buttons to control the projection TV.
Tips z
• If more than one code number is listed, try entering
them one by one until you come to the correct code
for your equipment.
• If you enter a new code number, the code number
you previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.