Connecting An Aerial And A Vcr To The Tv; Switching On The Tv - Sony KD-32DX150U Instruction Manual

Connecting an aerial and a VCR to the TV

3
Connecting an aerial only
RF Loopthrough
lead (supplied)
Connecting an aerial and a VCR
Scart lead
(not supplied)
Rear of VCR
4

Switching on the TV

Existing aerial lead
Existing aerial lead
RF Loopthrough
lead (supplied)
RF lead
(not supplied)
On/Off switch
1. Connect your existing aerial lead to the digital
socket marked
shown.
2.
Connect the supplied RF loopthrough cable from
the socket marked
marked .
1.
Connect your existing aerial lead to the digital
socket marked
2.
Connect the supplied RF loopthrough lead from the
lower socket marked
socket on your VCR.
3.
Connect a lead from the RF OUT socket of your
VCR to the analogue socket marked
4.
Connect a scart lead from the socket marked
3 s 3 on the rear of the TV to the scart socket
on your VCR (refer to your VCR instruction
manual).
5. Connect the VCR to the mains socket and switch
on.
6. Insert a pre-recorded tape into the VCR and press
the 'PLAY' button. This enables the TV to locate
and store the
'Automatically tuning the TV' procedure.
Note:
Your VCR sockets may not be labelled RF IN and RF OUT. If not,
please refer to your VCR instruction manual for guidance.
1. Connect the TV plug to your mains socket
(220 - 240 V AC, 50 Hz) and switch on.
2. Push in the on/off button (labelled
front of the TV.
Note:
If the red indicator on the front of the TV is lit the TV is in standby
/
mode. Press the TV button on the remote control to switch on
the TV. Please be patient as the picture may take a few moments to
appear on screen.
Getting started
on the rear of the TV as
to the analogue socket
on the rear of the TV as shown.
on the TV to the RF IN
on the TV.
video channel during
) on the
the
5