Sata Configuration - Gigabyte MSH87DI-SI User Manual

2-2-2 SATA Configuration
SATA Mode Selection
Select the on chip SATA type.
IDE Mode: When set to IDE, the SATA controller disables its AHCI function and runs in the IDE
emulation mode.
AHCI Mode: When set to AHCI, the SATA controller enables its AHCI functionality.
Options available: IDE/AHCI/Disabled. Default setting is AHCI Mode.
Serial ATA Port 0/Serial ATA Port 1/mSATA
The category identifies Serial ATA and mSATA types of hard disk that are installed in the computer.
System will automatically detect HDD type.
Note that the specifications of your drive must match with the drive table. The hard disk will not work
properly if you enter improper information for this category.
Hard drive information should be labeled on the outside device casing. Enter the appropriate option
based on this information.
Hot Plug (for Serial SATA Port 0/1)
Enable/Disable Hot Plug support for Serial ATA Port 0/1.
Options available: Enabled/Disabled. Default setting is Disabled.
- 37 - BIOS Setup