Data Table - IBM 5100 Maintenance Information Manual

DATA TABLE
Read/Write Storage
Location
3F70 8541 8645 8700
3F80 8000 0204 15EO
3F90 1560 OF64 FBFF
3FAO 05EE COOB OE47
3FBO 159F 8804 CE45
3FCO C185 AOO7 7FBO
3FOO 01C6 C103 0094
3FEO DC01 8000 FCOO
3FFO 0024 0000 0000
Test Description: When the program has begun to
execute, the 5103 platen should be rotating back and
forth. The accuracy of the emitter adjustment is
displayed with a series of arrows. If there are no binds
in the carriage and the emitter is in adjustment,
approximately 1 and 1/3 lines of arrows should be
pointing up, and 1 and 1/3 lines of arrows should be
point down.
If the lines of arrows are not with ± three arrows of
being the same length, the forms emitter needs to be
adjusted. If the print/ plot feature is on the system using
the printer, the emitter should be adjusted to give within
± one arrow of the same length lines.
Loosen the forms emitter and move it slightly in the
direction of the greater number of arrows. The length of
the lines of arrows is an indication of the relative
freedom from binds in the platen.
The pattern of arrows shown below would require a
slight downward adjustment of the emitter to obtain a
±
one arrow adjustment accuracy.
Data
A005 858B 868A 8740 840C
OF54 OB01 0500 C003 AOO5
05AE OC01 1500 1590 0904
OE45 D101 1593 01E6 5108
CE4E 0847 0807 01A4 01E7
OAE4 CMOC A011 FCOO 01CC
OF74 7FBO CB04 F005 1510
01CC 01C6
C103
F009 OD47
0000 0000
0000 0000 0000
tttttttttttttttttttttttttttttttttttftttttttttttttttttttttttttttttttttttttttttttttt
ttttttttttttttttttttttttttttt
~~~~~~~~~~~~~~~~~~~~~+++~+++++~~+~~~+~~++++++~+~+++++++++++++++++++++++++++++++~++
~~~~+~~~+~~~~~~~+~+++++~~+++~+~
3-110
\,