Table of Contents
Advertisement
Overview
Unpacking
Installation
This chapter describes the general procedures for positioning the S-AIT Tape
Drive Unit, connecting it to the host computer, and turning it on. This chapter
also describes initial setup. Installation and setup procedures may vary slightly
depending on your system.
Note
You will need the box and packing materials if you wish to move or transport
the unit. Retain them for future use.
1
Remove the unit from the box as indicated below.
Remove the packing materials, such as plastic covers and tapes.
2
Inspect the unit for shipping damage.
If there is damage, do not use the unit. Report the damage immediately by
contacting your dealer.
2
Chapter
Chapter 2 Installation
17
Advertisement
Table of Contents
