Table of Contents
Advertisement
Library Mode
The Library Mode can be enabled with a DIP switch.
ON
OFF
1
2
When switch 3 is ON, AIT-1, 2, 3 compatible Library Mode is enabled.
With this switch OFF, ACI Mode is enabled.
Terminator Power Control DIP switch
This DIP switch determines whether terminator power is supplied to the
SCSI bus. To enable terminator power, set position 5 [Terminator Power]
switch to ON.
Cleaning Request Mode
Periodic cleaning requests can be enabled by a DIP switch.
ON
OFF
1
2
When switch 6 is ON, cleaning requests are enabled. When enabled, the
"CLEANING REQUEST" LED on the front panel lights after every 100
hours of operation.
When this LED lights, clean the drive with a cleaning cartridge.
Note
To maintain the drive in optimum condition in environments affected by dust and other
contaminants, we recommend keeping cleaning requests enabled.
3
4
5
6
3
4
5
6
1 DR (Disaster Recovery) Mode
2 Emulation Mode
3 AIT Library Interface Mode (ON)
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req
7
8
7 DC Control (1)
8 DC Control (2)
1 DR (Disaster Recovery) Mode
2 Emulation Mode
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req (ON)
7
8
7 DC Control (1)
8 DC Control (2)
13
Advertisement
Table of Contents
