Changing The Pronto Settings; Support; Maintaining The Remote Control; Troubleshooting - Philips Pronto TSU9200 Starter Manual

2.6

Changing the Pronto Settings

Your installer has fully programmed your Remote Control. To change the Pronto Settings,
contact your installer.
3

Support

3.1

Maintaining the Remote Control

Protect the Remote Control from temperature extremes
Keep the Remote Control away from heaters and other heat sources.
The Remote Control is not waterproof
The Remote Control should not be exposed to rain or moisture.
Do not store or use the Remote Control in any location that is extremely damp or wet.
When you have spilled water on the Remote Control, remove the battery and place the
Remote Control in a clean environment to dry. Let it dry for 48 hours before reinserting the
battery.
Cleaning the Remote Control
• Use a soft, damp cloth to clean the Remote Control.
• If the screen is dirty, clean it with a soft cloth moistened with a diluted window-cleaning
solution.
• Do not use a corrosive detergent or an abrasive sponge.
• Avoid the use of abundant water.
3.2

Troubleshooting

The Remote Control goes to stand­by mode automatically
This is the time out feature of the Remote Control to save power. To adjust the time that the
Remote Control stays active, go to the Service Menu. See the warning on the next page on
how to do this.
The battery is not charging
When the battery is low and the Charging LED does not light up, make sure that:
• The adapter of the docking station is plugged into the wall outlet.
• The Remote Control is placed properly in the docking station.
• The contacts in the docking station are clean and free of obstructions.
If you notice that the battery is deteriorating, contact your installer for a replacement battery.
Enjoying Your Pronto Remote Control
TSU9200_END_EN-ES-FR.indb 11
11
14-09-2007 12:05:01