Kenwood NX-300 Service Manual page 7

3. Remove the coaxial cable from the GPS PCB.
Note: When you remove the coaxial cable from the GPS
PCB, remove perpendicularly to the GPS PCB.
4. Remove the GPS PCB from the connector (CN710) of
the Control PCB.
5. Affix the terminal of the coaxial connector to the fibrous
sheet (G10-1362-04) as shown in the figure.
Coaxial cable
Coaxial connector
GPS PCB
Coaxial cable
Fibrous sheet
(G10-1362-04)
6. Fold the fibrous sheet (G10-1362-04) in half, and cover
the terminal of the coaxial cable as shown in the figure.
Coaxial cable
Fibrous sheet
(G10-1362-04)
7. Insert the fibrous sheet into the slit of the holder as
shown in the figure.
NX-300(G)
7