Change The Fuse - KYMCO Many 110 EV Series User Manual

12. Change the fuse

Turn the main switch off to check for a blown fuse.
Only replace it with a fuse of specified capacity.
Identify the cause of a blown fuse before replacing it.
Remove the helmet box. The fuse is in the fuse box next to
the voltage converter.
Open the fuse box and pull the fuse out from the fuse clip.
Fuse specifications: four 5A fuses, one 10A fuse and one
30A fuse.
5A/58V: Controller/relay.
5A/58V: Voltage converter.
5A/32V: Main switch/ PO button/Start-up button/Side stand
switch/Reverse gear/USB charging.
5A/32V: Meter/Blinker/Relay/Low-Speed horn.
10A/32V: Light/Horn/Brake.
30A/32V: Lead acid battery.
OK NG
-54-
 Removal
Don't overstretch the fuse clip during removal.
 Assembly
Check if the fuse clip is loose after fuse installation. Does
the fuse get heated if the fuse clip is loose? This is the
main reason for a malfunction. Please be aware of this.
 Do not use a fuse with a capacity outside the specified
range. Such fuses are the main reason for overheated and
burnt wiring.
 Only replace electrical devices (lights, meters) with
original ones of specified ratings.
 If you use a non-genuine fuse or one with different
specifications, it will be easily blown with unbalance
battery loads.
 If the fuse blows soon after replacement, find out the
reason before replacing it again, otherwise it is likely that
the fuse will blow again. If you cannot find the reason, go
to an authorized shop, or Service Center for inspection.
 Avoid using strong frontal water jets to clean electric parts
when cleaning the vehicle.
Note