Advertisement
Install the camera after mounting the cable cover.
Step7
z
Remove the screw (binding head screw: M2.5 x 5 mm {1/4 inches}) from the lower backside of the
camera.
Note:
• Store the removed screw in a safe location for when you choose to remove the RS485
Output unit, as they will not be used from this point onwards.
x
Mount the camera to the ceiling or wall using the mount bracket, and connect the cables.
For more information about the installation and connection methods of the camera, refer to the cam-
era's Important Information or Installation Guide.
c
Fasten the cable cover to the rear side of the camera with the screws.
(Recommended tightening torque: 0.39 N·m {0.29 lbf·ft})
• Take care that no cables are caught in the cable cover.
v
Adjust the camera's direction, angle of view, and focus.
For more information about adjustment methods, refer to the Operating Instructions of the lens or the
Installation Guide of the camera.
Cable cover
Screw hole on the lower
backside of the camera
13
Advertisement
