Table of Contents
Advertisement
f The figure indicating the installation and removal of the Interface Board is
using the combination of the Interface Board for HDMI 2 input (Model No.:
ET-MDNHM10) and the optional projector (Model No.: PT-RQ13K) as an
example. Illustration of this document may vary from the actual product.
f The details of the installation or removal may be different depending on the
display device, so confirm the Operating Instructions of your display device
too.
How to install the Interface Board
Screws (4 locations)
Slot cover
Fig. 1
1)
Remove the slot cover. (Fig. 1)
f Remove the four screws fixing the slot cover of the display by rotating
counterclockwise with a Phillips screwdriver. The removed screws are
used to fix the Interface Board.
f When removing the fourth screw, hold the slot cover with your hand so
it will not fall.
f To replace from other Interface Board, remove the Interface Board
following the procedure in "How to remove the Interface Board"
(x page 8).
2)
Install the Interface Board to the display device. (Fig. 2)
f Insert the guide groove of the Interface Board aligned to the salient of
the slot. Insert the bracket firmly all the way in.
3)
Fix the Interface Board. (Fig. 3)
f Tighten and fix with the four screws removed in Step 1).
Attention
f The removed slot cover is required when the unnecessary Interface Board is removed. Store
it so it can be attached in the future.
Installing the Interface Board
Salient
Guide groove
Fig. 2
Screws (4 locations)
Fig. 3
ENGLISH - 7
Advertisement
Table of Contents
