Settings For Communication Fault; 1703 System Link - Siemens SICAM AK Manual

2.6.2.1

Settings for Communication Fault

2.6.2.1.1

1703 System Link

After creating the signals, select LNK_1703_SYS and edit the required values for configuring
as an input signal.
Select the parameter
Select the parameter
down menu.
Enter the value for the parameters
parameterization of CP-6010.
Enter the value for the parameters IOA1,
concept. The value must not be included in the list provided in the Appendix A,
of SICAM AK and
Select the parameter
BSE values via the pull-down menu.
Select the parameter
SSE values via the pull-down menu.
Select the parameter
configured error type via the pull down menu.
SICAM RTUs, SICAM AK Redundancy
DC2-026-2.07, Edition 10.2016
and
Lk_Reg Lk_Comp
as Error message sum diagnostics table
Lk_Cat
CASDU1
IOA2
CP-6010.
Error_location/BSE
Error_location/SSE
to Communication
Error_type
Unrestricted
via the relevant pull-down menu.
and value same as provided in the web
CASDU2
and according to the plant address
IOA3
to C1-CPU. You can also select any configured
to PRE1. You can also select any configured
Fault. You can also select any
Redundancy via CP-6010
via the relevant pull-
Configuration
119