Table of Contents
Advertisement
Troubleshooting (continued)
Symptom
The MD does not play
normally.
The MD does not play from
the first track.
The playback sound skips.
Noise is heard.
Noise is briefly heard.
During playback, the
operation lamp of the player
or the remote display does
not light up.
The group settings do not
function.
40
Cause/Solution
•
Stop playback when another play mode is selected. Then press and
hold the jog lever for two seconds or more.
•
When the repeat play is selected, press and hold the P-MODE
button for two seconds or more until
•
Playback with same MD starts from the point you last stopped
playing.
To start playback from the beginning of the same MD, press and hold
the jog lever on the remote for two seconds or more (or press and
hold the 5-way control key on the player toward
seconds or more). Or you can press
MD. Playback will start from the beginning because the player will
consider the MD to be a different one.
When you use the player in a location that has a lot of vibration, place
•
the player where the vibration is the least.
•
A very short track, such as a brief narration or introduction, may
cause sound to skip.
•
Do not continuously give strong shocks to the player.
Do not use a dirty or scratched MD.
•
•
Move the player away from a television or other source of strong
magnetism which is causing interference.
•
Because of the nature of the compression method used in the LP4
mode, noise may be output on very rare occasions during playback of
sound recorded in this mode.
•
Noise may be output when the cord of the headphones touches the
clothing, etc. This is not a malfunction.
•
When "Power Mode" is set to "Power Save," the lamp and display do
not light up except during operation. Select "Quick" or "Normal"
(page 31).
•
Insert an MD with group settings (page 25).
/
disappears.
for two
stop) button and reinsert the
(
Advertisement
Table of Contents
