Table of Contents
Advertisement
KX-TDE200GR
8.1.1.19. Utility-Refresh Activation Key
Allows you to enable the activation keys (except for the Activation Key for Software Upgrade to Enhanced Version) without
resetting the PBX.
This utility recounts the number of available activation keys, and refreshes the system data accordingly. To enable the activation
keys, it is necessary to change the card status of all virtual cards to OUS, then back to INS.
To enable the activation keys
1. Change the card status of all virtual cards to OUS.
2. From the Utility menu, click Refresh Activation Key.
3. Change the card status of all virtual cards back to INS.
8.1.1.20. Utility-System Reset-Reset by the Command
Updates the main system program and data files stored within the PBX using files taken from the SD memory card, and resets
the connected PBX.
This option is only available at Installer level.
Two copies of each of the main system files can be stored on the SD memory card. The names of these files are as follows:
File Name
DMSYS
DMSYS_S
PMMPR
PMMPR_S
When new DMSYS and PMMPR files are transferred from a connected PC to the SD memory card using the File Transfer PC to
PBX (SD Card) utility, they are stored as the backup files. To use these files on the PBX, it is necessary to first swap them with
the currently active files on the SD memory card.
To update system files and reset the PBX
1. From the Utility menu, point to System Reset and then click Reset by the Command.
2. Choose whether to back up current system data or not.
• Click SD Backup to back up the current system data to the SD memory card before proceeding.
Select this if you intend to use the current system data unchanged after reset.
• Click Skip to continue without backing up.
Select this if you intend to replace the current system data with data that was uploaded from the PC.
The second screen will be displayed. A list of matching files found on the SD memory card, with dates and times, is shown at
the top.
3. Select whether to replace the DMSYS and PMMPR files or not.
When no backup file is found, the corresponding options are not available.
4. Click OK.
A confirmation screen will be displayed.
5. Select an option:
• Click OK to reset the PBX.
If OK is clicked, a final confirmation screen will be displayed.
• Click Cancel to return to the main screen without copying files.
6. Click OK to reset the PBX, or Cancel to return to the main screen without copying files.
If the reset command was not carried out correctly, an error message will be displayed, and you will be returned to the main
screen.
After resetting the PBX with this command, it is necessary to reconnect to the PBX to continue programming.
8.1.1.21. Utility-Flash ROM ID Information
Displays the Flash ROM ID number pre-assigned to the PBX, used for PBX installation management.
To view the Flash ROM ID
• From the Utility menu, click Flash ROM ID Information.
Main system data file. Contains all of the current configuration data for the PBX.
Backup main system data file
PBX program file. Contains the software to run the IPCMPR board of the PBX.
Backup PBX program file
44
Description
Advertisement
Table of Contents
