Sony MDS-DRE1 Operating Instructions Manual page 17

7
Press the pad for the track you want to hot start.
Playback begins immediately.
To return to normal playback
Press PLAY MODE repeatedly until "HOT START"
disappears.
z In the Hot Start play mode, you can also use PLAY/PAUSE for
immediate playback of the hot start tracks
Pressing PLAY/PAUSE when the unit is stopped to immediately
play all the hot start tracks in the order that they were
programmed.
z The hot start settings remain available even after you exit
the Hot Start play mode.
Just press PLAY MODE repeatedly to display "HOT START" and
you can use the same hot start settings again.
z When using recordable MDs, the hot start settings remain
available even after you eject the MD
With recordable MDs, the hot start settings are written into TOC
data when the disc is ejected. The next time you load the MD,
you can use the same hot start settings simply by pressing PLAY
MODE repeatedly to display "HOT START".
With commercial MD software, the hot start settings are erased
when you eject the disc.
Notes
• During Hot Start playback, it is not possible to use the 0/)
buttons or the loop function. It is also not possible to use the
scrub dial during pause.
• Hot start settings are erased when a track is edited.
Checking the hot start settings
Press DISPLAY repeatedly while "HOT START" is
displayed.
The hot start tracks appear in the order they were
programmed.
For example: "/3 n 5 n 8 n 1 n 2/"
Changing the hot start settings
The hot start settings can be changed before beginning
playback.
To
Erase one track
all tracks
Add a track at beginning
in middle
to end
Change a track
* See "Starting Tracks as Quickly as Possible (Hot Start)" for
details on steps 1~2 and 3~5.
Do this*
Do steps 1~2, press 0/)
until the unwanted track blinks,
then press EDIT/NO.
Do steps 1~2, then press EDIT/
NO repeatedly.
1 Do steps 1~2, then press 0
to display a blinking "0" before
the first track.
2 Do steps 3~5.
1 Do steps 1~2, then press
0/) until the track after
which you want to add the new
track blinks.
2 Press AMS to display a
blinking "0".
3 Do steps 3~5.
1 Do steps 1~2, then press )
to display a blinking "0" after
the last track.
2 Do steps 3~5.
1 Do steps 1~2, then press
0/) repeatedly so that the
unwanted track blinks.
2 Do steps 3~5.
17 GB