Ill; Electronic Equipment Setup And Check - Shure C/PEK-3 Instruction Manual

,
&I
SPEAKER
11
I
/ - - -
I '
I \
i
1
\
<:;r
I
- - - /
I
I I
I I
L
-
- -
- -
- - - A
CUSTOMER'S
TURNTABLE
Ill. ELECTRONIC EQUIPMENT SETUP AND CHECK
,
GROUND
The following steps (A-H) refer to drawings (Fig. 1 and 2):
A. Connect the ground wire from the reference turntable to the binding post
marked "GND" on the back of the Test Panel.
B. Plug the left channel output from the reference turntable into "B Left" on
the back of the Test Panel.
C. Plug the right channel output from the reference turntable into "B Right"
on the back of the test panel.
D. Plug the C/PEK-3 power cord into a 120 Vac (50-60 Hz) outlet.
E. A listening test may be performed by connecting the monitor outputs on the
rear of the test panel to the magnetic phono inputs on a stereo amplifier. It
is recommended that a pair of good quality speakers be used. The volume
control of the stereo amplifier will control the listening volume only, and
will not affect the tests.
F. Connect the "Vert" output on the back of the test panel to the vertical input
of the oscilloscope.
G. Connect the "Horiz" output on the back of the test panel to the horizontal
input of the oscilloscope.
H. On the oscilloscope:
1. Set horizontal input to external.
2. Set vertical and horizontal sensitivity to approximately 150 mV/cm.
To test the reference turntable, depress the turntable selector switch on the test
panel ("ln:B"), follow the test sequence, start by testing the turntable speed.
INTEGRATED
STEREO
AMPLIFIER
-
-
---I
7
u
dL
IGHT
LEFT
I \
SPEAKER
OSCILLOSCOPE
VERTICAL
TEST PANEL
P l
l L I
MONITOR
OUTPUTS
REFERENCE
TURNTABLE
HORIZONTAL
I
SCOPE
'B"
INPUTS
0 0
- : - I