Chassis And Body - MARUTI SUZUKI Zen Supplementary Service Manual

Table of Contents

Advertisement

"a": Parking brake lever stroke:
3 – 8 notches (With 20 kg or
44 lbs of pull pressure)
Brake Fluid Change
CAUTION:
Since brake system of this vehicle is factory-filled with
brake fluid indicated on reservoir cap, do not use or mix
different type of fluid when refilling; otherwise serious
damage will occur.
Do not use old or used brake fluid, or any fluid from a un-
sealed container.
Change brake fluid as follows.
Drain existing fluid from brake system completely, fill system with
specified fluid and carry out air purge operation.
For air purging procedure, refer to Section 5.
Brake Lever and Cable Inspection
Parking brake lever
Check tooth tip of each notch for damage or wear. If any damage
or wear is found, replace parking lever.
Check parking brake lever for proper operation and stroke, and
adjust it if necessary.
For checking and adjusting procedures, refer to Section 5.
Parking brake cable
Inspect brake cable for damage and smooth movement.
Replace cable if it is in deteriorated condition.

CHASSIS AND BODY

Clutch Pedal Free Travel Inspection
Check clutch pedal (1) for height and free travel "a" referring to Sec-
tion 7C.
Adjust or correct if necessary.
MAINTENANCE AND LUBRICATION 0B-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents