Sony DVP-NS333 Operating Instructions Manual page 65

If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, damaging your ears or speakers.
DOLBY DIGITAL (DVD VIDEO/DVD-RW
only)
Selects the type of Dolby Digital signal.
D-PCM Select this when the player is
connected to an audio
component without a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
"DOWNMIX" item in
"AUDIO SETUP" (page 64).
DOLBY Select this when the player is
DIGITAL
connected to an audio
component with a built-in
Dolby Digital decoder.
MPEG (DVD VIDEO/DVD-RW only)
Selects the type of MPEG audio signal.
PCM Select this when the player is
connected to an audio
component without a built-in
MPEG decoder. If you play
MPEG audio sound tracks, the
player outputs stereo signals
via the DIGITAL OUT
(OPTICAL or COAXIAL)
jack.
MPEG Select this when the player is
connected to an audio
component with a built-in
MPEG decoder.
DTS (DVD VIDEO only)
Selects whether or not to output DTS signals.
OFF
Select this when the player is
connected to an audio
component without a built-in
DTS decoder.
ON
Select this when the player is
connected to an audio
component with a built-in DTS
decoder.
Note
When you use the DIGITAL OUT (COAXIAL or
OPTICAL) jack to listen to MPEG audio signals
and set "MPEG" to MPEG in "AUDIO SETUP", no
sound will come from your speakers if you select
one of the TVS mode.
65