Step 5: Install The Mounting Plate - Kenmore SPACEMASTER 85210 Installation Instructions Manual

STEP 5:
INSTALL THE MOUNTING PLATE
1. Remove the upper cabinet and wall templates.
NOTE: If you are venting the oven through the wall,
be sure you align the damper/connector on
the rear of the mounting plate with the
3 1/4"x10" duct. Be sure the damper moves
freely. See Figure 22.
2. Place the mounting plate against the wall and match
the screw holes.
3. Prepare the toggle bolts by attaching a spring toggle
head to the end of each toggle bolt as shown in
Figure 23.
NOTE: Be sure to leave at least one wall-thickness of
space between the head of the toggle bolt
and the spring toggle head so that the spring
toggle can open on the other side of the wall,
as shown in Figure 24.
4. Locate the stud holes (3/16") and insert the lag
screws through the mounting plate and into the holes.
See Figure 25.
5. Insert the toggle bolts through the dry wall holes
(3/4"). Tighten the toggle bolts.
6. Slide washer onto lock pin and place inside upper
cabinet for future use as directed on the next page.
See Figure 26.
lock pin
Figure 26
washer
- 14 -
wall mounting plate
mounting plate
toggle bolt
spring
wall
toggle bolt
toggle head
mounting plate
lag screw
Figure 22
spring
toggle head
Figure 23
Figure 24
mounting pate
Figure 25