2.2
The connection board
4 [14]
The connection board (CD96812) has two connectors to insert the CPU and I/O
board in.
On the board there are two DB9 D connectors for the two serial ports (Com 3 and 4).
COM 1 and 2 are accesible through screw connectors - only the TX, RX and GND
signals are available. They are used to connect the Cerberus control panels.
On the same connection board there is the power supply block. It has three pins: the
central one is the ground, the two laterals are marked + and -. You must connect here
a 13.8 Vdc voltage source.
Data and design subject to change without notice. Supply subject to availability
© Copyright by CERBERUS AG, CH-8708 Männedorf, Switzerland 1995
Cerberus Division
Product description
03.99
e1476.doc