Sony CFD-922L Operating Instructions

Use TYPE I (normal) tape only. Use TYPE I (normal) tape only.
Playing a tape Recording
1 1
Press TAPE (direct power-on). Press xZ to open the tape compartment and insert a
blank tape.
With the side you want to
Display
record on facing upward
c
2
Press xZ to open the tape compartment and insert a
recorded tape. Close the compartment.
2
Select the program source you want to record.
With the side you want to
play facing upward
To record from the CD player
Press CD and insert a CD (See "Playing a CD").
c
Display
3
Press N.
To record from the radio
Press RADIO BAND•AUTO PRESET and tune in the
station you want (See "Listening to the radio").
Display
To Press
adjust the volume VOLUME +, – (VOL +, – on the
remote, CFD-S32/S32L only)
stop playback xZ
3
fast-forward or rewind the tape M or m
Press z to start recording.
(N is depressed automatically.)
pause playback X
Press the button again to resume play
after pause.
eject the cassette xZ
turn on/off the player OPERATE (or POWER)
Notes on cassettes
• Break off the cassette tab from side A or B to prevent accidental
recording. If you want to reuse the tape for recording, cover the broken
tab with adhesive tape. To Press
stop recording xZ
Side A
pause recording X
Press the button again to resume recording.
turn on/off the player OPERATE (or POWER)
Tab for side A
Tab for side B
Tips
• Adjusting the volume or the audio emphasis will not affect the
• The use of a cassette with more than 90 minutes of play time is not
recording level.
recommended except for long, continuous recording or playback.
• CFD-S22L/S32L/922L only: If the MW/LW program makes a
whistling sound after you've pressed z in step 3, press PLAY MODE•
MONO/ST ISS (Interference Suppress Switch) repeatedly until the
noise is at a minimum.
• For the best results, use the AC power as a power source for recording.
• To erase a recording, proceed as follows:
1 Insert a tape with the recording you want to erase.
2 Press TAPE.
3 Press z.
On operation
Falling asleep to music
Precautions
• If the player is brought directly
from a cold to a warm location, or
On safety
is placed in a very damp room,
• As the laser beam used in the CD
moisture may condense on the
1
Play the music source you want. player section is harmful to the
lenses inside the CD player
eyes, do not attempt to
section. Should this occur, the
disassemble the casing. Refer
player will not operate properly.
servicing to qualified personnel
In this case, remove the CD and
2
only.
wait about an hour for the
Press SLEEP to display "SLEEP."
• Should any solid object or liquid
moisture to evaporate.
fall into the player, unplug the
• If the player has not been used for
player, and have it checked by
a long time, set it in the playback
qualified personnel before
mode to warm it up for a few
operating it any further.
minutes before inserting a
Cleaning the cabinet cassette.
• Clean the cabinet, panel and
If you have any questions or
controls with a soft cloth slightly
problems concerning your player,
moistened with a mild detergent
3
please consult your nearest Sony
Press SLEEP to select the minutes until the player goes solution. Do not use any type of
dealer.
off automatically. abrasive pad, scouring powder, or
solvent, such as alcohol or
Each time you press the button, the indication changes
benzine.
as follows: "60" n "90" n "120" n no indication n
On power sources
"10" n "20" n "30."
• For AC operation, check that the
Display
player's operating voltage is
identical with your local power
supply (see "Specifications") and
use the supplied mains lead; do
not use any other type.
The voltage selector is located at
the bottom of the player (for
Brazilian model only).
To cancel the sleep function • The player is not disconnected
from the AC power source
Press OPERATE (or POWER) to turn off the power.
(mains) as long as it is connected
to the wall outlet, even if the
Note
player itself has been turned off.
When you are playing a tape using this function:
• For battery operation, use six R20
If the tape length of one side is longer than the set time, the player will
(size D) batteries.
not go off until the tape reaches the end.
• When the batteries are not to be
used, remove them to avoid
damage that can be caused by
battery leakage or corrosion.
• The nameplate indicating
operating voltage, power
consumption, etc. is located at the
bottom.
On placement
• Do not leave the player in a
location near heat sources, or in a
place subject to direct sunlight,
excessive dust or mechanical
shock.
• Do not place the player on an
inclined or unstable place.
• Do not place anything within 10
mm of the side of the cabinet. The
ventilation holes must be
unobstructed for the player to
operate properly and prolong the
life of its components.
• If the player is left in a car parked
in the sun, be sure to choose a
location in the car where the
player will not be subjected to the
direct rays of the sun.
• Since a strong magnet is used for
the speakers, keep personal credit
cards using magnetic coding or
spring-wound watches away from
the player to prevent possible
damage from the magnet.
Dimensions
Tape Player
Troubleshooting Specifications
The tape does not move when you
press an operation button.
Mass
General
• Close the cassette compartment CD player section
The power does not come on. securely. System
Compact disc digital audio system Supplied accessory
• Connect the mains lead securely. The REC z button does not
Laser diode properties
• Make sure the batteries are function or the tape does not play
Material: GaAlAs
inserted correctly.
or record. Wave length: 780 nm
Emission duration: Continuous Design and specifications are subject to
• Replace all the batteries with new • Make sure the safety tab on the
Laser output: Less than 44.6 µW change without notice.
ones if they are weak.
cassette is in place.
(This output is the value measured at a
• You cannot turn on the player
• Make sure "TAPE" appears in the distance of about 200 mm from the Optional accessories
with the remote when you operate objective lens surface on the optical
display. Sony MDR headphone series
pick-up block with 7 mm aperture.)
the player on batteries (CFD-S32/
Poor or distorted playback, Spindle speed
S32L only).
200 r/min (rpm) to 500 r/min (rpm)
recording or erasing quality.
(CLV)
The power is not on, and
• Clean the heads, pinch roller and
Number of channels
"bAttErY" and "Error" are
capstan with a cleaning swab 2
displayed alternately.
slightly moistened with cleaning
Frequency response
• Make sure the batteries are
fluid or alcohol. 20 - 20,000 Hz +1/–2 dB
inserted correctly. Wow and flutter
• Replace all the batteries with new
Below measurable limit
• Replace all the batteries with new
ones if they are weak.
ones if they are weak.
• TYPE II (high position) or TYPE Radio section
IV (metal) tape is being used. Use
There is no audio.
Frequency range
TYPE I (normal) tape only.
• Make sure the function you want
CFD-S22/S32
• Demagnetize the heads using a
to use appears in the display.
commercially available tape head FM 87.5 - 108 MHz
• Adjust the volume.
demagnetizer. or 87.6 - 108 MHz
• Unplug the headphones when
AM 531 - 1,602 kHz
listening through speakers.
Record/playback head
Capstan CFD-S22L/S32L/922L
Noise is heard.
• Someone is using a portable FM 87.5 - 108 MHz
telephone or other equipment that
MW 531 - 1,602 kHz
emits radio waves near the player.
LW 153 - 279 kHz
tMove the portable telephone,
Erase head Pinch roller
etc., away from the player.
IF
FM: 10.7 MHz
CD Player Lens AM/MW/LW: 450 kHz
Aerials
The CD does not play or "no dISC" FM: Telescopic aerial
lights in the display even when a AM/MW/LW: Built-in ferrite bar
aerial
CD is in place.
• Make sure that the CD
Cassette-corder section
compartment is closed.
Recording system
• Place the CD with the label
4-track 2 channel stereo
surface up. Fast winding time
• Clean the CD. Approx. 120 s (sec.) with Sony cassette
C-60
• Take out the CD and leave the CD
Frequency response
compartment open for about an
Remote (CFD-S32/S32L only) TYPE I (normal): 70 - 10,000 Hz
hour to dry moisture
The remote does not function.
condensation. General
• Replace all the batteries in the
• Make sure "Cd" appears in the Speaker
remote with new ones if they are Full range: 10 cm dia., 3.2 ohms, cone
display.
type (2)
weak.
The sound drops out. Outputs
• Make sure that you are pointing
Headphones jack (stereo minijack)
• Reduce the volume. the remote at the remote sensor on
For 16 - 68 ohms impedance
• Clean the CD, or replace it if the the player. headphones
CD is badly damaged.
• Remove any obstacles in the path Maximum power output
2.3 W + 2.3 W
• Place the player in a location free of the remote and the player.
Power requirements
from vibration.
• Make sure the remote sensor is
For CD radio cassette-corder:
• Clean the lens with a
not exposed to strong light such Brazilian model:
commercially available blower. as direct sunlight or fluorescent 110 - 120V, 220 - 240V AC
• The sound may drop out or noise lamp light. selectable, 50/60 Hz
Other models:
may be heard if the CD is • Move closer to the player when
230 V AC, 50 Hz
recorded using a personal
using the remote.
9 V DC, 6 R20 (size D) batteries
computer(CD-R,etc.).
For remote control (CFD-S32/S32L only):
3 V DC, 2 R6 (size AA) batteries
After trying the above remedies, if
Radio Power consumption
you still have problems, unplug the
AC 20 W
The audio is weak or has poor mains lead and remove all the
Battery life
quality. batteries. After all the indications in
For CD radio cassette-corder:
the display disappear, plug the
• Replace all the batteries with new FM recording
power cord and insert the batteries
ones if they are weak.
again. If the problem persists, please Sony R20P: approx. 13.5 h
• Move the player away from the
consult your nearest Sony dealer.
Sony alkaline LR20: approx. 20 h
TV.
Tape playback
The picture of your TV becomes
unstable. Sony R20P: approx. 7.5 h
• If you are listening to an FM
Sony alkaline LR20: approx. 15 h
program near the TV with an
CD playback
indoor antenna, move the player
Sony R20P: approx. 2.5 h
away from the TV.
Sony alkaline LR20: approx. 7 h
Approx. 420 165 256 mm (w/h/d)
Notice for customers in the
(16 ⁄ 5 6 1 ⁄ 10 1 ⁄ inches) (incl.
8 2 8 WARNING
projecting parts) United Kingdom
A moulded plug complying with
Approx. 4.1 kg (9 lb. 1 oz) (incl. To prevent fire or shock
BS 1363 is fitted to this equipment
batteries)
hazard, do not expose the
for your safety and convenience.
player to rain or moisture.
Mains lead (1)
CD Radio
Remote control (1) (CFD-S32/S32L only)
Should the fuse in the plug
supplied need to be replaced, same
Cassette-
To avoid electrical shock, do
rating fuse approved by ASTA or
not open the cabinet. Refer
BSI to BS 1362, (i.e. marked with
Corder
servicing to qualified
or mark) must be used.
personnel only.
If the plug supplied with this
equipment has a detachable fuse
Information
Operating Instructions
cover, be sure to attach the fuse
For customers in Europe
cover after you change the fuse.
Never use the plug without the fuse
cover. If you should lose the fuse
cover, please contact your nearest
Sony service station.
About this manual
The instructions in this manual are
CFD-S22
This Compact Disc player is for the CFD-S22, CFD-S22L, CFD-
classified as a CLASS 1 LASER S32, CFD-S32L and CFD-922L.
CFD-S22L
product. Before you start reading, check
your model number. The CFD-S32L
CFD-S32
The CLASS 1 LASER PRODUCT
is the model used for illustration
label is located on the bottom
purposes.
CFD-S32L
exterior.
CFD-922L
Note
WARNING The name of the switch to turn on/
off this player is indicated as below:
Do not install the appliance in a
"OPERATE": CFD-S22L/S32L/
Sony Corporation © 2000 confined space, such as a bookcase
or built-in cabinet.
"POWER":
3-043-356-31(1)
Choosing Power Sources
Connecting the mains lead Using the player on batteries
Insert one end of the supplied mains lead to the AC IN socket located at the Insert six R20 (size D) batteries (not supplied) into the battery compartment.
rear of the player, and the other end to the mains.
Notes
• Replace the batteries when the OPR/BATT indicator dims or when the
player stops operating. Replace all the batteries with new ones. Before
you replace the batteries, be sure to take out the CD from the player.
• To use the player on batteries, disconnect the mains lead from the player.
Inserting batteries into the remote
(CFD-S32/S32L only)
1
to AC IN
2
to the mains
Insert two R6 (size AA) batteries (not supplied)
Replacing batteries
Brazilian model only: Adjusting the voltage
With normal use, the batteries should last for about six months. When the
Be sure to set the VOLTAGE SELECTOR (at the
remote no longer operates the player, replace all the batteries with new
bottom) to your local power supply.
ones.
Note
When you operate the player on batteries, you cannot turn on the player
using the remote.
Tip
Only for the customers supplied with an AC plug adaptor:
Use the supplied AC plug adaptor if the plug of the main lead does not
match your outlet.
English
922L
CFD-S22/S32