Table of Contents
Advertisement
Displays the following information about the link between a transmitter and receiver:
◦
Not Linked: The transmitter is not linked to a receiver
◦
Linked: The transmitter is linked to a receiver. Select Unlink? to free the transmitter from the receiver link.
◦
Unlinked: The transmitter is not linked to a receiver
SL Test
ShowLink test tool to measure the boundaries of ShowLink coverage.
Marker
When enabled, press the enter button to drop a marker in Wireless Workbench.
Battery
Displays battery information:
◦
Battery Life: Runtime reported in bar display and time (hours:minutes)
◦
Charge: Percentage of charge capacity
◦
Health: Percentage of current battery health
◦
Cycle Count: Total of the number of charging cycles for the installed battery
◦
Temperature: Battery temperature reported in Celsius and Fahrenheit
Talk Sw
Press ENTER to add control from a talk switch. Press the button on the talk switch twice to complete the link.
Identify
When enabled, Identify flashes the transmitter icon in Wireless Workbench Inventory or Monitor tabs.
About
Displays the following transmitter information:
◦
Model: Displays the model number
◦
Band: Displays the tuning band of the transmitter
◦
FW Version: Installed firmware
◦
HW Version: Hardware version
◦
Serial Num: Serial number
Reset All
Restores all transmitter parameters to factory settings.
IR Sync
Use IR Sync to form an audio channel between the transmitter and receiver.
Note: The receiver band must match the band of the transmitter.
1.
Select a receiver channel.
2.
Tune the channel to an available frequency using group scan or manually turn to an open frequency.
3.
Power on the transmitter.
4.
Press the SYNC button on the receiver.
Shure Incorporated
12/23
Advertisement
Table of Contents
