Siemens SCALANCE M-800 Getting Started page 10

Connecting SCALANCE M-800 to WAN
1.1 Procedure in principle
Required components
● SCALANCE M-800
● Optional if the device is not mounted directly. Standard rail with fittings
● A power supply 24 VDC or 12 VDC with cable connector and terminal block connector
● A network cable complying with the IE FC RJ-45 standard for Industrial Ethernet
● One PC for the configuration
Additionally with the SCALANCE M87x
● A suitable antenna
● A SIM card of your mobile wireless provider
The required services, for example the Internet, must be enabled.
Additionally with the SCALANCE M81x
● Activation for ADSL
Steps in configuration
The required steps in configuration depend in part on the device you are using. If the
SCALANCE M826 is used in 2-wire operation, only the configuration step "Setting up
SCALANCE M-800 and the network" is required. After this, the SCALANCE M826 is ready
for operation immediately (out of the box).
1. Setting up SCALANCE M-800 and the network.
For the SCALANCE M826, note the additional information in the section "Connecting
SCALANCE M826 with SHDSL"
2. When necessary configure the device with the Primary Setup Tool (PST) or DCP
Discovery
3. If applicable, adapt the IP configuration of the PC.
4. Start Web Based Management.
5. Log in to Web Based Management.
6. Configure the SCALANCE M-800.
– Specify device information
– Set the time of day
– Only with the devices SCALANCE M87x and SCALANCE M81x:
– Only with the devices SCALANCE M87x and SCALANCE M81x:
– Only with the SCALANCE M826 in 4-wire operation:
– Allow access
10
Configure access data
Set up the host name
Configure SHDSL
Getting Started, 01/2019, C79000-G8976-C337-07