Assembly And Installation [Specialist] - Viessmann DN25B Installation, Start-Up And Service Instructions Manual

Solar-Divicon DN25B Installation, Start-up, Service
3

Assembly and installation [specialist]

The solar station may only be installed indoors with a power supply of 120 V / 60 Hz. The installation site must be dry,
stable and frost-free.
Material damage due to high temperatures!
Since the solar fluid may be very hot near the
collector, the fitting assembly must be installed at a
sufficient distance from the collector field.
It may be necessary to install an upstream tank, in

order to protect the expansion tank
Solar-Divicon DN25B Installation Steps:
1. Remove the station from the packaging.
2.
Pull off the front shell.
3. Hold the solar station to the mounting location and
level the unit. Mark the mounting hole locations
(next to the temperature gauges) onto the mounting
surface.
4. Drill the holes into the mounting surface, and fasten
the solar station to the wall by means of the
enclosed screws and, if required, the enclosed wall
anchors.
7