Install Manual Linkage; Installation Of Check Balls, Front Servo, Gaskets, Spacer And Solenoid - Buick LeSabre 1965 Service Manual

SUPER TURBINE " 4 0 0 '
DISASSEMBLY & ASSEMBLY 5 - 1 4 3
Figure 5-731
Figure 5-728
3. If necessary, i n s t a l l a new
rear seal, using Seal Installer
Tool J-21464. See Figure 5-727.
5-29 INSTALL MANUAL
LINKAGE
1. If necessary, i n s t a l l a new
manual shaft seal into the case.
2. If removed, insert the accu-
mulator rod into manual detent
lever from side opposite pin.
3. Install the actuator rod re-
taining " E " ring.
4. Install the actuator rod plunger
under the parking bracket and
over the parking pawl.
5. Install the manual lever and
shaft assembly through the case
and d e t e n t lever.
5-728.
See Figure
6. Install the retaining hex-lock
nut on the manual shaft. See Fig-
ure 5-730.
NOTE: Start hex-nut on manual
shaft, engaging manual valve with
detent pin.
7. Install retaining pin indexing
with groove in manual shaft. See
Figure 5-731.
5 - 3 0 INSTALLATION OF
CHECK BALLS,
FRONT SERVO,
GASKETS, SPACER
AND SOLENOID
1. Install the front servo spring
and retainer into the transmis-
sion case.
Figure 5-730
Figure 5-732
Figure 5-733
2. Install flat washer on front
servo pin on end opposite taper.
3. Install pin and washer into case
so that tapered end is contacting
band.
4. Install oil seal ring on front
servo piston if removed, and in-
stall on apply pin so that identi-
fication numbers on shoulders are
positioned toward bottom of pan.
See Figure 5-732.
5. Check freeness of piston by
stroking piston bore.
6. Install six (6) check balls into
the transmission case pockets.
See Figure 5-733.
7. Install the valve body spacer to
case gasket. (Gasket with exten-
sion for solenoid).
8. Install valve body to case
spacer plate.
9. Install the solenoid gasket. See
Figure 5-734.
10. Install the solenoid assembly
with connector facing outer edge
of case, using attaching bolts.
NOTE: Do not tighten bolts at
this time.
11. Install the " O " seal ring on
the solenoid connector.