Page 2
To reduce the risk of SEVERE INJURY to persons: • DO NOT enable the Chamberlain Universal Smartphone Garage Door Controller if operating either one-piece or swinging doors. To be enabled ONLY on a sectional door. Read instructions thoroughly BEFORE beginning.
Page 3
INSTALL THE DOOR SENSOR Top Panel Top Panel of Garage Door of Garage Door Fastening Strips Door Test BUTTON Front Sensor Cover Screws Position the door sensor vertically and attach to a clean, dry location on the top panel of the garage door with fastening strips (provided). Press in the bottom of the door sensor and remove the front cover.
Page 4
INSTALL THE WI-FI HUB Anchors Light Bracket Screws Wi-Fi Hub Install the bracket for the Wi-Fi hub on the ceiling near the garage door opener. Use the bracket as a template and mark holes for the bracket. Be sure the Wi-Fi hub is visible when standing in the path of the door.
AND ALL OTHER DEVICES: 1. Go to the mobile device’s Wi-Fi Settings and turn on Wi-Fi. 2. Locate the list of available Wi-Fi networks and select “MyQ-nnn” network. 3. Launch the mobile device’s web browser and type “setup.myqhome.com” into the web browser’s address bar.
Chamberlain Technical Support at 1-800-528-9131. ONE YEAR LIMITED WARRANTY The Chamberlain Group, Inc. warrants to the fi rst retail purchaser of this product that is free from defect in materials and/or workmanship for a period of 1 year from the date of...
Page 7
NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment or modifi cations of this transceiver are prohibited. THERE ARE NO USER SERVICEABLE PARTS. This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 9
Controlador telefónico universal para puertas de garaje INSTRUCCIONES RESUMIDAS...
Page 10
ADVERTENCIA Para reducir el riesgo de accidentes LESIÓNES GRAVES: • NO usar el controlador universal de puertas de garaje para teléfono inteligente con puertas de una pieza ni puertas giratorias. Activarlo ÚNICAMENTE en puertas seccionales. Leer las instrucciones ANTES de comenzar. Para usar este producto en instalaciones ALTO residenciales, el abre-puerta debe ser un modelo...
Page 11
INSTALAR EL SENSOR DE PUERTA Panel Superior Superior de la Puerta Panel Superior de la Puerta Bandas Fjación El BOTÓN Sensor Cubierta de Prueba de Puerta Delantera Tornillos Coloque el sensor de puerta vertical y coloque en un lugar limpio y seco en el panel superior de la puerta del garaje con bandas de fi...
Page 12
INSTALE EL DISTRIBUIDOR DE WI-FI Taquete Soporte Tornillos Distribuidor de Wi-Fi Instalar el soporte en el techo, cerca del abre-puerta de garaje. Usar el soporte como plantilla y marcar los agujeros de montaje. Al estar de pie bajo la puerta abierta, tener siempre a la vista la luz de alerta del distribuidor de Wi-Fi.
Page 13
Bluetooth. 4. Siga las indicaciones en pantalla para agregar el distribuidor de Wi-Fi a la red y luego descargue la aplicación de control LiftMaster MyQ ® NOTA: La conexión del distribuidor de Wi-Fi a Internet podría llevar algunos minutos.
Apoyo Técnico de Chamberlain al 1-800-528-9131. GARANTÍA LIMITADA DE UN AÑO The Chamberlain Group, Inc. garantiza al primer comprador minorista de este producto, que el mismo está libre de defectos de materiales y de mano de obra por un período de...
Page 15
AVISO: Las normas de la FCC de EE.UU; y las normas IC de Canadá prohíben la modifi cación de este transceptor. NO HAY PARTES QUE PUEDA REPARAR EL USUARIO. Este dispositivo cumple con la parte 15 de las Reglamentaciones de la FCC de EE.UU.